Language:

How To Install Chain Link ?

Update Time:2022/7/13

How To Install Chain Link ?

When installing the chain, wrap the chain around the sprocket first and then thread it through the chain pins. When threading the chain pin, it should be passed from the inside to the outside, so that the connecting plate can be installed and locked from the outside. When disassembling, after removing the locking piece, use a hammer to lightly tap the two coupling pins on the same coupling plate in turn, pull out the pin shaft, and remove the chain. If the chain pin head is thickened by the riveting head, it can be ground and then disassembled.

The sprocket should be mounted on the shaft without skew and wobble. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprockets is less than 0.5 meters, the allowable deviation is 1 mm; when the center distance of the sprockets is more than 0.5 meters, the allowable deviation is 2 mm. However, it is not allowed to have the phenomenon of friction on the side of the sprocket teeth. If the offset of the two wheels is too large, it will easily lead to off-chain and accelerated wear. Care must be taken to check and adjust the offset when replacing sprockets.

You can see the video about how to install the chain link .